Loading...
Loading...
All product recalls associated with SILVER EAGLE.
Total Recalls
6
Past Year
0
Class I (Serious)
0
Most Recent
Oct 2024
Data from FDA, USDA, CPSC, and NHTSA public records. Recall counts vary by company size, industry, and reporting practices. Always check official sources for current information.
Silver Eagle Manufacturing Company (Silver Eagle) is recalling certain eye and shank assemblies, models VAST20W, CTL40W, and CTA40W. The eye and shank welds may fatigue and crack, allowing and the eye to separate from trailer converter dolly.
Silver Eagle Manufacturing Company (Silver Eagle) is recalling certain 2021 VAST20W trailer converter dollies. The ballast hanger near the rear of the frame may fail, causing part of the ballast hanger and its counterweights to fall onto the roadway.
Silver Eagle Manufacturing Company (Silver Eagle) is recalling certain 2018 Vast20W converter dolly trailers, equipped with MPA/MTA suspensions and Meritor EX225 brakes. The brake caliper bolts on these axles may not be properly torqued which can allow the caliper to detach from the mounting flange. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Brake Systems."
Silver Eagle Manufacturing Company (Silver Eagle) is recalling certain model year 2014-2015 VAST-20N, VAST-20W, and CTL-40W Converter Dollies manufactured February 6, 2014, to March 4, 2015. Due to a problem with the brake valve, the affected dollies may experience brake drag.
Silver Eagle Manufacturing Company (Silver Eagle) is recalling certain model year 1999-2001 VAST20W and 2001 CSL20W trailer converter dollies. The affected dollies were incorrectly built to have a hole in the center of the axle beam pointing downward. The hole at the bottom causes a stress crack in the tension side of the beam resulting in axle failure.
SILVER EAGLE IS RECALLING CERTAIN MODEL YEAR 2010-2011 HAWK, TANDEM AND FALCON DOLLIES MANUFACTURED FROM NOVEMBER 18, 2010, THROUGH MARCH 24, 2011, AND EQUIPPED WITH GUNITE AUTOMATIC SLACK ADJUSTERS. DUE TO AN INCOMPLETE "KNITTING" OF THE IRON AT THE TIME OF CASTING, INADEQUATE STRUCTURAL INTEGRITY OF THE SLACK ADJUSTER HOUSING CAN OCCUR, WHICH COULD CAUSE THE HOUSING TO BREAK AT THE HANDLE UNDER NORMAL OPERATING LOADS.