Evaporator Coil Drain Pans (Daikin) – incorrect marking (2024)
Hazard assessment based on recall description.
This AI-generated summary is provided for general informational purposes only and is derived from publicly available recall notices. It supplements but does not replace official agency classifications or safety instructions.
Check Your Product
According to the U.S. Consumer Product Safety Commission (CPSC)
Product
Evaporator coil drain pans
Brand
Daikin Comfort Technologies Manufacturing L.P. (f/k/a Goodman Manufacturing Company L.P.) of Houston, Texas
Lot Codes / Batch Numbers
Not specified in CPSC notice. Check official source for details.
Product Images
Source: U.S. Consumer Product Safety Commission
Daikin Comfort Technologies Manufacturing L.P. (f/k/a Goodman Manufacturing Company L.P.) of Houston, Texas is recalling Evaporator coil drain pans. The hazard is: The molded plastic drain pan located at the bottom of the evaporator coil can overheat, melt and def. Based on CPSC recall notice.
Summary derived from CPSC notice
The following details were not provided by CPSC: UPC codes.
Reason for Recall
As stated by CPSC
This recall expansion includes certain units manufactured between January 2019 and February 2020 that were incorrectly marked. DCT recently discovered that a limited number of evaporator coils that were manufactured during that time frame were incorrectly marked with a 2018 serial number, indicating that the unit was manufactured in 2018. The recall scope now includes about 3,600 additional units with the following configurations and coil serial numbers, as shown in the table below: Type Coil Configuration Affected Furnace Brands Affected Coil Serial Numbers Dates Sold Condensing furnace system Up-Flow (Coil above Furnace) All Prefixes ranging from 1901 through 2101 and certain prefixes ranging from 1811-1812 Jan. 2019 through Nov. 2021 Non-condensing furnace system (Certain configurations) Up-Flow (Coil above Furnace) Any "competitor" brand (excludes Goodman, Daikin or Amana branded furnaces) Prefixes ranging from 1901 through 2101 and certain prefixes ranging from 1811-1812 Jan. 2019 through Nov. 2021. NOTE: Furnace systems that were repaired with a new evaporator coil drain pan between January 2019 and November 2021, with the serial number range listed above, are also included in this recall. Whether a non-condensing furnace system falls within the scope of the recall depends on the location of the burners, which, if unknown, can be verified through DCT's model verification tool at: https://www.recallrtr.com/drainpan. Affected units can be identified through serial numbers found on the evaporator coil or the case, which sits atop the vertically installed furnace. The furnace brand and model number can be found on the furnace on the "Energy Guide" label. Consumers can refer to the instructions on Goodman's model verification tool at: https://www.recallrtr.com/drainpan. The model number of the outdoor condenser may also be required and can be found on a label attached to the product.
Reported concern (CPSC)
The molded plastic drain pan located at the bottom of the evaporator coil can overheat, melt and deform, posing a fire hazard.
Recommended Action
Per CPSC guidance
Consumers should contact Daikin Comfort Technologies Manufacturing L.P. (DCT) to determine whether your unit is included in this recall and to register for the free repair by a qualified technician. DCT is contacting all registered consumers where records indicate their gas furnace system is subject to the recall.
Verify this information on the official source
For complete details and official instructions, check the U.S. Consumer Product Safety Commission (CPSC) directly.
View official CPSC recall noticePage updated: Jan 10, 2026