FORD 2010 FORD F-450 SD Recall
Check Your Product
According to the National Highway Traffic Safety Administration (NHTSA)
Product
2010 FORD F-450 SD
Brand
FORD
Lot Codes / Batch Numbers
Not specified in NHTSA notice. Check official source for details.
Products Sold
Model Year 2010
Iowa Mold Tooling Co., Inc. is recalling certain 2010 FORD F-450 SD vehicles due to equipment issues. The leaking oil may soak into the thermal blanket covering the exhaust, which when combined with heat from exhaust, may result in an increased risk of.
Summary derived from NHTSA notice
Reason for Recall
As stated by NHTSA
Iowa Mold Tooling Co., Inc. will notify owners and dealers to inspect the Muncie PTO pressure switch to determine if it is from the range of defective switches and if required, remove the pressure switch assembly and put a plug in the port where the PTO switch had been installed. This switch was never being utilized. This will be done free of charge. The recall is expected to begin in mid-July 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.
Reported concern (NHTSA)
The leaking oil may soak into the thermal blanket covering the exhaust, which when combined with heat from exhaust, may result in an increased risk of fire.
Recommended Action
Per NHTSA guidance
Iowa Mold Tooling Co., Inc. will notify owners, and dealers will install a new pressure switch kit that moves the switch away from the exhaust system, free of charge. The recall began on July 28, 2014. Owners may contact Iowa Mold Tooling Co., Inc. at 1-800-247-5958.
Verify this information on the official source
For complete details and official instructions, check the National Highway Traffic Safety Administration (NHTSA) directly.
View official NHTSA recall noticePage updated: Jan 10, 2026