Guard Security Power Strip Surge Protectors (Howard Berger) – Safety Issue (1997)
Hazard assessment based on recall description.
This AI-generated summary is provided for general informational purposes only and is derived from publicly available recall notices. It supplements but does not replace official agency classifications or safety instructions.
Check Your Product
According to the U.S. Consumer Product Safety Commission (CPSC)
Product
Guard Security Hardware power strip surge protectors
Brand
Howard Berger
Lot Codes / Batch Numbers
Not specified in CPSC notice. Check official source for details.
Howard Berger is recalling Guard Security Hardware power strip surge protectors. The hazard is: Electrocution/Electric Shock. Based on CPSC recall notice.
Summary derived from CPSC notice
The following details were not provided by CPSC: remedy information, UPC codes.
Reason for Recall
As stated by CPSC
Power Strip Surge Protectors Recall by Howard Berger NEWS from CPSC U.S. Consumer Product Safety Commission Office of Information and Public Affairs Washington, DC 20207 FOR IMMEDIATE RELEASE CONTACT: Ken Giles April 22, 1997 (301) 504-7052 Release # 97-109 CPSC, Howard Berger Inc. Announce Recall of Power Strip Surge Protectors WASHINGTON, D.C. - In cooperation with the U.S. Consumer Product Safety Commission (CPSC), Howard Berger Inc. of Brooklyn, N.Y., is recalling about 30,000 power strip surge protectors. The power strip surge protectors have undersized wires and loose connections, presenting fire, shock, and electrocution hazards. CPSC and Howard Berger Inc. are not aware of any injuries involving these surge protectors. This recall is being conducted to prevent the possibility of injury. The surge protector has 8 outlets. It is made of a beige-colored plastic with a red power switch and a black reset button. The power switch and reset button are located on the raised end of the surge protector, which is about 1/2 inch higher than the outlets. The electrical cord is beige. The following words are embossed on the bottom of the surge protector, "8 Outlet Power Strip...MP8...Made in China." There is a silver label affixed to the bottom of surge protector that reads, "UL Listed 50E8." The surge protector was packaged in a clear plastic bag with a cardboard header. Labeling on the bag reads in part, "Guard Security Hardware...Made in China." Labeling on the cardboard header reads in part, "8 Outlet Power Center...MP8...Made in China." Discount, variety, and hardware stores in the Northeast sold the surge protectors from January 1995 through October 1996 for about $6. Consumers should stop using the recalled surge protectors immediately and return them to the stores where purchased for a full refund. For more information, consumers should call Howard Berger Inc. at (800) 695-4827. Consumers who live in the New York metropolitan area should call (718) 272-1540. CPSC learned of this problem during joint surveillance with the U.S. Customs Service.
Reported concern (CPSC)
Electrocution/Electric Shock
Recommended Action
Per CPSC guidance
The CPSC advises consumers to stop using the product. Contact the manufacturer or return the product to the place of purchase.
Verify this information on the official source
For complete details and official instructions, check the U.S. Consumer Product Safety Commission (CPSC) directly.
View official CPSC recall noticePage updated: Jan 6, 2026