Porter-Cable MAG-Saw Circular Saw – Safety Repair (2005)
Check Your Product
According to the U.S. Consumer Product Safety Commission (CPSC)
Product
Porter-Cable® 7¼-inch MAG-Saw™ Circular Saws
Brand
Porter-Cable, of Jackson, Tenn.
Lot Codes / Batch Numbers
Not specified in CPSC notice. Check official source for details.
Product Images
Source: U.S. Consumer Product Safety Commission
Porter-Cable, of Jackson, Tenn. is recalling Porter-Cable® 7¼-inch MAG-Saw™ Circular Saws. The hazard is: The lower guard on these saws could stick in the open position, posing a risk of severe lacerations . Based on CPSC recall notice.
Summary derived from CPSC notice
The following details were not provided by CPSC: UPC codes.
Reason for Recall
As stated by CPSC
The recall involves Porter-Cable® 7¼-inch MAG-Saw™ Circular Saws with model numbers 324MAG (serial numbers 10001 through 108962), 325MAG (serial numbers 10001 through 014712), 423MAG (serial numbers 10001 through 100371), and 424MAG (serial numbers 10001 through 012690). The model and serial numbers are located on a label on the top of the saws. Units marked with a "T" at the location shown below have been inspected and are not affected by this recall. "Porter-Cable®" is written on the side of these saws.
Reported concern (CPSC)
The lower guard on these saws could stick in the open position, posing a risk of severe lacerations to consumers.
Recommended Action
Per CPSC guidance
Consumers should stop using the circular saws immediately and contact Porter-Cable for the location of the nearest service center to receive a free inspection and repair, if necessary.
Verify this information on the official source
For complete details and official instructions, check the U.S. Consumer Product Safety Commission (CPSC) directly.
View official CPSC recall noticePage updated: Jan 6, 2026