Loading...
Loading...
All product recalls associated with UTILIMASTER.
Total Recalls
1000
Past Year
353
Class I (Serious)
22
Most Recent
Jan 2026
Data from FDA, USDA, CPSC, and NHTSA public records. Recall counts vary by company size, industry, and reporting practices. Always check official sources for current information.
Shyft Group is recalling certain 2021-2022 Utilimaster Walk-In vans. The tie rod clamps may be loose, which could result in loose tie rod ends that could break or detach.
Magna International Inc. (Magna) is recalling certain Magna Steyr fuel tanks with part numbers 1000045620, 1000043710, and 1000045350. The two halves of the fuel tank may not have been welded properly, which could result in a fuel leak.
There is the potential for contaminated water to enter parts of the Heater-Cooler Unit circuits. There is a potential risk of bacterial contamination including Mycobacteria species.
The internal profile of the Triathlon Prim (Baseplate) is potentially oversized; there may be a witness mark (taper) at the bottom of the internal profile of the baseplate, which prevents the insert from locking on the baseplate.
Customized coronal rod benders may deform the implant when used with the spinal system devices.
There is a potential that 7F sheaths are packaged as 10F sheaths.
Customized coronal rod benders may deform the implant when used with the spinal system devices.
Daimler Trucks North America, LLC (DTNA) is recalling certain 2019-2022 Freightliner Cascadia P4, 2021 Western Star WH126, 2020 Western Star WJ121, and 2021-2022 Western Star 49X vehicles. The battery cable terminal may break, resulting in a loss of electrical power and unintended engine stall.
The firm identified a precipitation issue which may cause late Ct reactors (a false positive result) with a rate of 5 to 10% for affected vials of RNA Master Mix.
Baking mixes contained an ingredient, tigernut flour, which was recalled because it was potentially contaminated with Salmonella.
Shyft Group is recalling certain 2021 Utilimaster Velocity vehicles. The Tire and Loading Information placard incorrectly states a seating capacity of one, although the actual seating capacity is two. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims."
Rossmonster Vans LLC (Rossmonster) is recalling certain 2018 Ram Promaster vehicles. The saddle valve securing bolt may be overtightened, possibly damaging the o-ring seal and causing a continuous gas leak.
There is a potential that the coin cell battery used to monitor X-Ray tube temperature may deplete early causing the system to become inoperable.
There is a potential that the coin cell battery used to monitor X-Ray tube temperature may deplete early causing the system to become inoperable.
Due to a design issue, inflation syringe handle separating from the inflation device when handle is withdrawn.
intermittent failure causes a blender initialization fault upon start-up, or during an EPGS calibration attempt following the 15-minute warm-up period. The control sliders on the Central Control Monitor (CCM) are disabled and the gas system can only be controlled by the local control knobs
Two unsuitable 3mL syringes with conventional needles for vaccine administration included in some Moderna 140 Ancillary Convenience Kits.
In the Azurion system, the user can add a new study to a patient by selecting the option Add Study . The Add Study dialogue box is then displayed where the Patient Type is selected to perform the study. Due to a software defect, when the study is initiated by pressing Start Procedure , the Patient Type changes inadvertently to a Patient Type different than the one selected as shown in the Table below. Patient type is one of the factors involved in the dose control process. The incorrect patient type changes the technique factors to be used by the system without notification to the user.
Butter microwave popcorn bags were packaged in organic salted popcorn consumer boxes and therefore contain undeclared milk
The MRI system contains a component that does not meet the appropriate flame retardancy-rating which could result in smoke or fire.