Hot Tub Drain Fittings (Hydro Air) – suction hazard (1982)
Hazard assessment based on recall description.
This AI-generated summary is provided for general informational purposes only and is derived from publicly available recall notices. It supplements but does not replace official agency classifications or safety instructions.
Check Your Product
According to the U.S. Consumer Product Safety Commission (CPSC)
Product
Hydro Air suction drain cover fittings
Brand
Hydro Air
Lot Codes / Batch Numbers
Not specified in CPSC notice. Check official source for details.
Hydro Air is recalling Hydro Air suction drain cover fittings. The hazard is: Entrapment. Based on CPSC recall notice.
Summary derived from CPSC notice
The following details were not provided by CPSC: remedy information, UPC codes.
Reason for Recall
As stated by CPSC
Hot Tub Suction Drain Fittings Recalled by Hydro Air NEWS from CPSC U.S. Consumer Product Safety Commission Office of Information and Public Affairs Washington, DC 20207 FOR IMMEDIATE RELEASE May 28, 1982 Release # 82-023 Recall Of Hot Tub, Spa, Whirlpool Suction Drain Fitting Because Of Hair Entrapment WASHINGTON, D.C. --The U.S. Consumer Product Safety Commission in cooperation with Hydro Air Industries Inc., Orange, California, today announced a voluntary recall of approximately 125,000 suction drain cover fittings for spas, hot tubs and whirlpools because of the danger of hair entrapment. Three incidents have occurred when pre-teenage girls put their heads under water and their long hair became entangled in the suction drain cover fitting. Two incidents resulted in death by drowning, and in one incident the victim was pulled free. Water is drawn from the spa through 3-5/8 inch plastic suction fitting or drain covers located on the wall of the spa l-3 inches from the bottom. A powerful strong suction exists at the water outlet suction fitting or drain cover when the high speed whirlpool suction is turned on. The Hydro Air suction drain cover fittings can be identified by the three slots on the face of the fitting cover. The middle slot measures 3/16 inches by l-1/2 inches and the two slots on either side measures 3/16 inches by l-1/4. These suction/drain cover fittings have been sold nationwide since 1979. Most sales occurred within California, Arizona, Texas and Florida. Consumers should immediately stop using their hot tubs, spas and whirlpools. They should contact the company responsible for the installation, or Hydro Air Industries, Inc. (1317 W. Grove, Orange, CA 92665, Telephone: 714-974-1920, call collect), to determine whether their unit has a defective suction/drain cover and to make arrangements for a free replacement.
Reported concern (CPSC)
Entrapment
Recommended Action
Per CPSC guidance
The CPSC advises consumers to stop using the product. Contact the manufacturer or return the product to the place of purchase.
Verify this information on the official source
For complete details and official instructions, check the U.S. Consumer Product Safety Commission (CPSC) directly.
View official CPSC recall noticePage updated: Jan 6, 2026